. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. REMARK The oil level will vary depending upon the oil temperature. Accordingly, use the following as the guide: Before operation: around L level (Oil temperature 10 to 30 ° C (50 to 86 ° F)) Normal operation: around H level (Oil temperature 50 to 80 ° C (122 to 176 ° F)) 3 - 45 1.
If the work equipment i diagram on the right, sta speed, retract the arm a lower the boom, set the bu and stop the engine. s not in the position shown in the rt the engine, run the engine at low nd bucket cylinder rods fully, then cket teeth in contact with the ground, 2. Open the engine rear cove r and cooling cover. For details, see "COOLING COVER (PAG E 3-29)". 3. Confirm that the oil level is between the H and L marks of sight gauge (G). NOTICE Do not add oil above the H line. This will damage the hydraulic circuit or cause the oil to spurt out.
If oil has been added above the H level, stop the upper structure so that the drain plug (P) under the hydraul ic tank will be between both tracks, and stop the engine and wait for the h ydraulic oil to cool down, then drain the excess oil from drain plug (P). 4. If the oil level is below the L mark, open the dirt cover, move the cover on top of oil filler por (F). t (F), then add oil through oil filler port