. OPERATION MACHINE OPERATIONS AND CONTROLS Check Electric Wiring WARNING 3 - 47 Check Water Separator If red ring (1) of the water sep there is no water. arator is at the bottom of case (2), If re the If th e ring (1) is floating, there is water up to the bottom of the ring, so 1. 2. 3. 4. 5. drain the water as follows. Open the engine rear cove r. position (A). n the accumulated water until red , then tighten plug (4). Set handle (3) to CLOSED Loosen drain plug (4), drai ring (1) reaches the bottom Set handle (3) to OPEN po Drain any water or sedimen sition (B). t from the fuel tank. For details, see "DRAIN WATER AND S (PAGE 4-26)".
EDIMENT FROM FUEL TANK I f the fuses frequently blow or i f there are traces of short circuits in th e electrical wiring, locate th e cause and immediately p erform repairs, or contact your Komatsu distributor for repairs. K eep the top surface of the batte ry clean and check the breather hole in the battery cap. If it is clogg ed with dirt or dust, wash t he battery cap to clean the brea ther hole. Ch eck for damage to the fuse, that a fuse of the specified capacity is being used, that there are no signs of any hort circuit in the wiring. Also check for loose terminals, and tighten any loose battery, starting motor, and alternator. aterial is accumulated around the battery, remove it.
, contact your Komatsu distributor. ty is being used, that the re are no signs of any disconnection, breakage, or s terminals found. Be sure to check wiring for the battery, starting motor, and alternator. In a ddition, if any flammable m aterial is accumulated around the b For troubleshooting and repairs , contact your Komatsu distributor. Check Function of Horn he ON position. unds immediately when the horn 1. 2. Turn the starting switch to t Confirm that the horn so button is pressed. If the horn does not sound, c ontact your Komatsu distributorfor repair.