Fifth Wheels and Trailer Couplings 2 plunger. The kingpin can be released only by manu- ally operating the release handle. The adjustment nut will compensate for wear on the lock or kingpin. Fifth Wheel Locking Operation Locking the Fifth Wheel Mechanism 2 1 CAUTION Before attempting to lock or unlock the fifth wheel lock mechanism of a sliding type fifth wheel, the slide release plungers must be in the locked position (flush with the mounting bracket edge). This prevents the sliding member from moving rapidly to the far forward or rearward po- sition, which could damage the fifth wheel mem- ber or kingpin. 3 f310528 02/12/96 1. Release Lever 2. Up-Shock Bushing 3.
Plunger Adjustment Type "B" Kingpin Lock Mechanism (Fig. 10.5) Fig. 10.4, Single Manual Release Slide 1. Chock the front and rear of the trailer tires to prevent the trailer from moving. The Type "B" kingpin lock mechanism utilizes two spring-loaded lock halves. The final forward motion of the kingpin into the open lock halves forces the locks to close in a 360 degree grip around the shoul- der and neck of the kingpin, positioning sliding yokes between the lock halves and tapered rib members of the fifth wheel understructure. The kingpin can be released only by manually operating the kingpin lock control handle. The adjustment nut will compensate for wear on the lock or kingpin.
WARNING Keep the fifth wheel plate lubricated to prevent binding between the tractor and trailer. A binding fifth wheel could cause erratic steering and loss of vehicle control, possibly resulting in serious personal injury or death. 2. The kingpin lock mechanism must be fully open, and the fifth wheel plate must be completely lu- bricated with chassis grease. For lubrication in- structions, see Group 31 of the Heavy-Duty Trucks Maintenance Manual. Lockguard (Fig. 10.6) The Holland lockguard is a device that prevents a false lockup, and is used with Type "B" kingpin lock mechanisms.
The Lockguard is a spring-tensioned, smooth-surfaced tongue that the kingpin passes over and depresses when entering the lock mechanism. The Lockguard will prevent the locks from engaging before the kingpin fully enters the locks. If the kingpin enters the fifth wheel incorrectly and does not de- press the tongue, the locks are unable to close. 3. Position the tractor so that the fifth wheel lock opening is in line (both vertically and horizontally) with the trailer kingpin. The kingpin should be in a position to enter the throat of the locking mechanism, to prevent a false lockup. See Fig. 10.6 .
Adjust the trailer landing gear to give enough alignment height so that the fifth wheel picks up the trailer on the fifth wheel ramps. Type "A" Kingpin Lock Mechanism (Fig. 10.7) 4. With the fifth wheel lock opening aligned with the trailer kingpin, back the tractor slowly toward the trailer, making sure that the kingpin correctly en- ters the throat of the locking mechanism. When the trailer is picked up by the fifth wheel, stop the tractor, then continue slow backward motion until positive lockup occurs. The Type "A" kingpin lock mechanism utilizes a single hinged lock and a cam arm.
The final forward motion of the kingpin into the open lock forces the hinged lock to pivot on a pin and close around the kingpin. The lock is held in place by a spring loaded 5. Apply the tractor parking brakes. 10.2