Freightliner FLD Conventional — FLD Conventional

Fifth Wheels and Trailer Couplings Operation Trailer Hookup 1. Chock the front and rear tires of the trailer. 2. Remove the cotter pin, then lift the lock and raise the latch. 3. Back up the vehicle until the drawbar eye is over the pintle hook. 4. Lower the trailer until the drawbar eye rests on the pintle hook. 5. Close the latch, then insert the cotter pin. NOTICE Always make sure the connect-hanger/support keeps the trailer air hoses and electrical cables positioned so that they do not rub on anything. Rubbing may wear through hoses or cables, re- sulting in air leaks, or exposed or broken wires, potentially affecting trailer brake or electrical sys- tems. 6.

Hook up the trailer’s electrical and air lines. 7. Remove the chocks from the trailer’s tires. Trailer Release 1. Apply the truck and trailer parking brakes. WARNING Do not use the trailer air supply for parking trail- ers not equipped with spring parking brakes. This applies the trailer service brakes only. As air bleeds from the trailer brake system, brake appli- cation is lost. This could allow the unattended vehicle to roll away, possibly resulting in serious personal injury or death. 2. Chock the front and rear tires of the trailer. 3. Disconnect the trailer air and electrical lines. Plug the air lines to keep out dirt. 4. Take the weight of the trailer drawbar off the pintle hook. 5.

Open the latch by first removing the cotter pin, then lift up the lock and raise the latch. 6. Slowly drive the vehicle away from the trailer. 10.19