Vehicle Access 4. Move your lower hand to a higher position on the grab handle. 5. Step onto the deck plate. Exiting the Back-of-Cab Area When climbing down from the deck plate, use the grab handle and access steps as follows: 2 1. Facing the center of the deck plate, grasp the grab handle with both hands. 2. Step one foot at a time to the top step. 3. Move your upper hand to a lower position on the grab handle. 4. Move one foot to the bottom step. 3 5. Move your upper hand to a lower position on the grab handle. 6. Step to the ground with your upper foot first.
Battery Box Cover 1 To remove the battery box cover, pull on the end of each holddown latch until the end clears the cover- mounted catch. See Fig. 3.12 . Pivot the latches out of the way, then lift off the cover. When installing the cover, be sure it is positioned properly before fasten- ing the latches. 1 09/24/2007 f602335 Hood Tilting 1. Steps 2. Grab Handle 3. Deck Plate The hood can be tilted to a full-open position. A grab handle at the front of the hood provides a hand-hold for hood tilting. See Fig. 3.13 . Tilt-assist springs (FLD 120 Conventionals) or a torsion bar (FLD 112 Conventionals), help you to tilt the hood open, and to return it to the operating position.
Stop cables (FLD 120 Conventionals), or hood straps (FLD 112 Con- ventionals), prevent the hood from overtravel. In the operating position, the hood is secured to the lower cab side panels by a hold-down latch on each side of the hood. Fig. 3.11, Back-of-Cab Access To Tilt the Hood 1. Apply the parking brakes. 01/18/95 f540036a 2. Release both hood hold-down latches by pulling the end outward. Fig. 3.12, Battery Box Cover 3.6