Freightliner FLD Conventional — FLD Conventional

Seats and Seat Belts Bunk Restraint Operation (See Fig. 5.22) Sleeper Compartment Bunk Restraints General Information 2 3 4 On vehicles equipped with a sleeper compartment, bunk restraints should be used whenever the sleeper compartment is occupied and the vehicle is moving. Restraints are designed to lessen the chance of in- jury or the amount of injury resulting from accidents or sudden stops. For this reason, Daimler Trucks North America LLC urges the use of bunk restraints when the sleeper compartment is occupied in a mov- ing vehicle. 5 WARNING f910069a 01/18/95 1 Do not use the sleeper compartment while the vehicle is in motion unless a bunk restraint is installed and used.

Not using the bunk restraint increases the chance of injury, or the degree of injury, from accidents or sudden stops to all oc- cupants of the vehicle. 1. Mattress 2. Sleeper Wall 3. Buckle 4. Link 5. Belt Anchor Fig. 5.22, Bunk Restraint in 40-Inch Sleeper Shown Belt Adjustment (See Fig. 5.21) 1. Starting at the foot of the bunk, pull up the link end of the belt far enough to engage the buckle. 2. Fasten the belt by pushing the link end into the buckle until they latch. Make sure that the belt is not twisted. Check the engagement by trying to pull the link out of the buckle. If they come apart, repeat this step. If the problem continues, re- place the belt.

Repeat steps 1 and 2 for the other two belts located in the middle and upper portion of the bunk to lock the restraint in place. 2 1 A 3 NOTE: On 60-inch raised roof cabs, the upper bunk restraint, if present, pulls up in front of the bunk and fastens at the ceiling. 01/06/95 f910068a A. Pull on the loose end to shorten the belt. 1. Buckle 2. Belt Release Button 3. Link 3. To release the bunk restraint, push the release button on the buckle at the head of the bunk and pull the link from the buckle. Fig. 5.21, Belt Adjustment Repeat this step for the other two buckles to completely release the bunk restraint. 1. Make sure the belt is attached to the bunk sup- port and sleeper wall. NOTE:

When the sleeper compartment is not occupied, the bunk restraint can be stored under the mattress. 2. To lengthen the belt, tip the link end downward and pull the link until it connects with the buckle. 3. After the belt is connected, shorten it by pulling on the loose end until the belt is snug, but com- fortable. Be sure the belts are not twisted. 5.11