Freightliner FLD Conventional — FLD Conventional

Steering and Brake Systems Steering System General Information control, which could result in an accident and possible physical injury. Power Steering System When there is no load on the vehicle, and the front tires are pointed straight ahead, the steering wheel spokes should be at the 4 and 8 o’clock positions, ±10 degrees. See Fig. 6.1 . See Group 46 of the Heavy-Duty Trucks Service Manual for steering ad- justment procedures. The power steering system consists of a steering gear (which includes a manual steering mechanism, a hydraulic control valve, and a hydraulic power cyl- inder), hydraulic hoses, power steering pump, reser- voir, and other components.

Some models are also equipped with a separate hydraulic power cylinder on the right side of the front axle. The power steering pump, driven by the engine, provides the power as- sist for the steering system. If the engine is not run- ning, there is no power assist. If the power-assist feature does not work due to hydraulic fluid loss, steering pump damage, or some other cause, bring the vehicle to a safe stop. Do not drive the vehicle until the cause of the problem has been corrected.

° 2 WARNING Driving the vehicle without the power-assist fea- ture of the steering system requires much greater effort, especially in sharp turns or at low speeds, which could result in an accident and possible injury. f460307a 05/24/94 1. 8 o’Clock 2. 4 o’Clock Fig. 6.1, Power Steering Wheel Position (with tires pointed straight ahead) Drivers should carefully use the power available with a power steering system. If the front tires become lodged in a deep chuckhole or rut, drive the vehicle out instead of using the steering system to lift the tires from the hole.

Also, avoid turning the tires when they are against a curb, as this places a heavy load on steering components and could damage them. CAUTION Never steam clean or high-pressure wash the steering gear. Internal damage to gear seals, and ultimately the steering gear, can result. Brake System General Information Manual Steering Gear Lubrication When operating in temperatures continuously below 30°F (–1°C), using the wrong type of lubricant in the steering gear could make the steering wheel difficult to turn.

To prevent trouble in cold temperatures, be sure that the steering gear lubricant complies with the cold weather recommendations specified in Group 46 of the Heavy-Duty Trucks Maintenance Manual. A dual air brake system uses a single set of brake controls to operate two independent air brake sys- tems. Each system has its own reservoirs, plumbing, and brake chambers. The primary system operates the service brakes on the rear axle; the secondary system operates the service brakes on the front axle. Service brake signals from both systems are sent to the trailer. WARNING Failure to comply with the cold weather recom- mendations could cause inadequate steering 6.1 10° 10°