1 page 1 Models J08C-TP and J08C-TR 3-11-10 ENGINE RADIATOR AND INTERCOOLER CHECK THE RADIATOR. Check the radiator for coolant leakage and clogging of the fins. NOTE : When carrying out high pressure washing to re- move fin clogging, do not apply excessive pres- sure to the fins which may cause deformation and consequent performance deterioration. SM3-J226A Fig. 23 INSPECT THE RADIATOR CAP. Check the filler cap pressure using a cap tester. Cap Pressure : 0.4 - 0.6 kg/cm 2 (5.69 - 8.53 lb/sq. in.) NOTE :
If the cap pressure is incorrect, there is a risk of abnormally high pressure being generated in the cooling system, which may cause the hose to drop off or burst and, in turn, damage the engine. SM3-J227 Fig. 24 CHECK THE INTERCOOLER. The intercooler is used to cool the overheated intake air charged by the turbocharger, and is installed at the front of the radiator. When mud, debris, etc. becomes attached to the front of the core, the passage of cooling air is impaired, so such matter should be removed completely by washing with water. Deformed fins also can impair cooling, and should be repaired. when changing intercooler hoses, clean the inside by blow- ing with air. NOTE :
Do not use water to clean the inside of the intercooler body. Using water will cause engine trouble, etc. RADIATOR INTERCOOLER Fig. 25 SM3-J719 INSTALLATION OF COMPONENT PARTS INSTALL THE COOLANT PUMP. NOTE: Refer to page 3-17-1. INSTALL THE THERMOSTAT CASE. NOTE: Refer to page 3-17-1. INSTALL THE COOLING FAN AND FAN CLUTCH. NOTE: Refer to page 3-17-2.