1 page 1 Models J08C-TP and J08C-TR 3-14-6 ENGINE 5. STARTING THE ENGINE IN COLD WEATHER In a diesel engine, fuel injected into the combustion cham- ber ignites by the temperature itself resulting from the compressed air in the cylinder. This temperature is high enough to ignite the fuel under normal operating condi- tions; however, when the ambient temperature is low, the temperature resulting from the compressed air may be insufficient to ignite the injected fuel. 1. This engine is provided with glow plugs as standard equipment, in order to facilitate engine starting when the ambient temperature is low.
It is also possible to install the following devices to assist starting at low temperature. a. An approx. 2" threaded hole is provided at the front of the right hand side of the cylinder block to permit installation of an immersion type coolant heater. b. It is also possible to install four batteries as an op- tion in order to improve starting performance. 2. Installation of coolant heater. When installing a coolant heater on the engine, first drain off the engine coolant. After installing the re- spective heaters, again supply suitable quantities of coolant, and then start the engine and confirm that there is no leakage of coolant from the respective mounting faces.
COOLANT HEATER SM3-J738 Fig. 12 WARNING When a coolant immersion heater is used, carefully read the manufacturer’s instructions. NOTE: When not using the coolant heater for summer, remove it from the engine and keep it.