Hino J08C-TP, J08C-TR — LIQUID GASKET AND APPLICATION POINTS

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-20-1 LIQUID GASKET AND APPLICATION POINTS The following liquid gasket is used for this engine. Liquid gasket specification ThreeBond TB1207B (04132-1217): Black ThreeBond TB1211 (04132-1211): White 1. COATING LIQUID GASKET AND PARTS ASSEMBLY PROCEDURE 1. Completely remove old liquid gasket from each part and the respective mating part, and re- move oil, water, and dirt using a cloth. 2. Be careful not to apply excessive or insufficient liquid gasket. Also, be sure to overlap the start and end of each coating. 3. When assembling coated parts, be careful that there is no misalignment between mating parts.

If there is any misalignment, coat the parts again. 4. Assemble the various parts within 20 minutes after applying liquid gasket. If more than 20 min- utes have elapsed, remove the liquid gasket and apply it again. 5. After assembling the various parts, wait for at least 15 minutes before starting the engine. 2. REMOVING PARTS When removing each part, do not attempt to pry one portion of the flange alone but use flange collar or clearance to pry the flange at several points alternately. When using a tube of liquid gasket, use the winding key provided. In the case of a catridge type, use commercially available application gun.

Winding key Application gun Cartridge type 300 g (0.66 lb) Tube 100 g (0.22 lb) Fig. 1 Fig. 2 SM3-J029 SM3-J030 Also, when using a tube, you can regulate the coating width by cutting the end of the nozzle at a suitable position. (1): Coating width approx. 2 mm (0.08 in.) when nozzle cut at 1st step (2): Coating width approx. 5 mm (0.20 in.) when nozzle cut at 2nd step (1) (2) Tube nozzle Fig. 3 SM3-J031