Hino J08C-TP, J08C-TR — DISMOUNTING THE ENGINE ASSEMBLY

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-4-5 22. REMOVE THE EXHAUST PIPE AND MUFFLER. SM3-J601A Fig. 22 23. REMOVE THE PROPELLER SHAFT. 1. Remove the center bearing support. NOTE: Attach a hoist to the propeller shaft. 2. Loosen the flange, then remove the propeller shaft. SM3-J602 Fig. 23 24. REMOVE THE TRANSMISSION. 1. Place a jack under the bottom of the flywheel hous- ing. 2. Place a transmission jack under the transmission. WARNING The engine must be suspended with a hoist until completion of disassembly of the transmission assembly. Fig. 24 SM3-J502 3. Remove the mounting bolt of the mounting rubber behind the transmission. 4.

Remove the mounting bolt of the transmission at the clutch housing, then remove the transmission. NOTE: Jack up and align the transmission with the en- gine, then pull the transmission straight out.