Hino J08C-TP, J08C-TR — CRANKSHAFT FRONT END, OIL PAN, FLYWHEEL AND FLYWHEEL HOUSING

1 page 1 Models J08C-TP and J08C-TR 3-7-4 ENGINE 2. Remove the flywheel mounting bolts. 3. Hold a copper rod through the starter hole against the flywheel and drive the rod lightly with a hammer to remove the flywheel from the crankshaft while rotating the crankshaft. WARNING The flywheel is heavy. When removing, be careful not to drop it on your feet. SM3-J656 Fig. 9 6. REMOVE THE CRANKSHAFT OIL FRONT AND REAR SEALS. 1. Remove the crankshaft oil seals with the special tool. Special tool: Oil seal puller (09420 - 1731) for front (09420 - 1742) for rear a. Place the plate at the crankshaft end using the crank pulley mounting bolts (front) or the flywheel mount- ing bolts (rear).

PLATE SM3-J119 Fig. 10 b. Install the hook to the crankshaft end using the bolt supplied. NOTE: Engage the hook with the oil seal notch. c. Remove the installed bolt in step a. HOOK REMOVE AFTER HOOK INSTALLATION Fig. 11 SM3-J120 d. Install the center bolt and tighten it to remove the oil seal. CENTER BOLT Fig. 12 SM3-J121 7. REMOVE THE DUST COVER. Fig. 13 SM3-J657