OPERATION LIFT ARM CONTROL LEVER This lever (6) operates the lift arm. This lever (6) operates the lift arm. Position (a): RAISE When the lift arm control lever is pulled further from the RAISE position, the lever is stopped in this position. When the lift arm reaches the preset position of the kick-out, the lever is returned to the HOLD position. Position (b): HOLD The lift arm is kept in the same position. Position (c): LOWER Position (d): FLOAT The lift arm moves freely under external force. Do not use the FLOAT feature when traveling forward, the bucket will dig in and raise the front of the machine. The FLOAT feature should only be used in reverse.
BRAKE PEDAL When traveling downhill, downshift the transmission to use the engine as a brake. When needed, use the right brake pedal. Do not use the brake pedals repeatedly unless necessary. Do not rest your foot on either the left or right brake pedal. These pedals (7) operate the brakes. Right Brake Pedal The right brake pedal operates the wheel brakes, and is used for normal braking. Left Brake Pedal The left brake pedal operates the wheel brakes, and if the transmission cut-off switch is at “ON”, it also returns the transmission to neutral. If the transmission cut-off switch is at “OFF”, the left brake pedal acts in the same way as the right brake pedal.
Remark When the accelerator is being used for operating the work equipment, always use the left brake pedal to slow or stop the machine after putting the transmission cut-off switch to the “ON” position. 2-64 WA480-5L