OPERATION START-UP PROCEDURES When performing start-up checks, be sure your machine is in a well ventilated area. 1. Turn the ignition switch to “ON” position. CHECK MONITOR PANEL 2. Check that all the monitor lamps, the gauges and the warning lamp light up for about 3 seconds and the alarm buzzer sounds for about 1 second. If the lamps do not light up, there is probably a failure or disconnection, so contact your Komatsu distributor for inspection. Remark It is important that a pre-operational check be performed at the beginning of your work shift, even if you are taking the machine operations over from another operator, always perform a pre-operational check before you start work.
CHECK FUEL LEVEL, ADD FUEL When adding fuel, never let the fuel overflow. This action may cause a fire. If any fuel is spilled, wipe it up completely. Never bring the flames near the fuel because it is highly flammable and dangerous. Remark If the engine has run out of fuel and has stopped, it is necessary to operate the priming pump to bleed the air completely from the fuel line before starting the engine again. Take care not to let the engine stop because of lack of fuel. If the engine has run out of fuel, the air bleeding operation can be performed more quickly if the fuel tank is completely filled with fuel. WA480-5L 2-83