Komatsu — TOWING THE MACHINE

OPERATION TOWING THE MACHINE If this machine must not be towed except in emergencies. When towing the machine, take the following precautions. 1. Align the towing pin (1) with groove (2) in the counterweight, then insert the pin and turn it 180 0 . 2. To prevent the towing pin from turning, fold the handle of the towing pin and set it in position. Reverse this operation to remove the pin. 3. Never use a wire rope which has cut strands (A), reduced diameter (B), or kinks (C). There is danger that the rope may break during the towing process. 4. Before releasing the brakes, put blocks under the wheels to prevent the machine from moving.

If the wheels are not blocked, the machine may suddenly move. 5. When towing a machine, tow it at a low speed of less than 2 km h (1.2 MPH), and for a distance of a few meters to a place where repairs can be carried out. If the machine must be moved long dis- tances, use a transporter. 6. To protect the operator if the towing rope or bar should break, install a protector plate to the machine being towed. 7. If it is impossible to operate the steering and brakes of the machine being towed, do not let anyone ride on the machine. 8. Check that the tow rope or bar is of ample strength for the weight of the machine being towed.

If the machine being towed must travel through mud or up hills, use a tow rope or bar of a strength of at least 1.5 times the weight of the machine being towed. 9. Keep the angle of the tow rope as small as possible. Keep the angle between the center lines of the two machines to within 30 degrees. 10. If the machine is moved suddenly, the tow rope or bar will be subjected to an excessive load, and it may break. Start the machine gradually and travel at a constant speed. 11. The towing machine should normally be of the same class as the machine being towed.

Check that the towing machine has ample braking power, weight, and rim pull to allow it to control both machines on slopes or on the tow road. 12. When towing a machine downhill, use a larger machine for towing to provide ample rim pull and braking power, or connect another machine to the rear of the machine being towed. This way it is possible to prevent the machine from losing control and turning over. 13. Towing may be carried out under various differing conditions, so it is impossible to determine beforehand there requirements for towing. Towing on flat horizontal roads will require the minimum rim pull, while towing on slopes or on uneven road surfaces will require the maximum rim pull.

WA480-5L 2-117