MAINTENANCE DO NOT DROP THINGS INSIDE THE MACHINE When opening inspection windows or the oil filler port of the tank to perform an inspection, be careful not to drop nuts, bolts, or tools inside the machine. If such things are dropped inside the machine, it will cause damage and malfunction of the machine, and will lead to failure. If you drop anything inside the machine, always remove it immediately. Do not put unnecessary things in your pockets. Carry only things which are necessary for inspection. DUSTY WORKSITES When working at dusty worksites, do as follows: Inspect the air cleaner clogging monitor frequently to see if the air cleaner is clogged.
Clean the air cleaner element at a shorter interval than specified. Clean the radiator core frequently to avoid clogging. Clean and replace the fuel filter frequently. Clean electrical components, especially the starting motor and alternator, to avoid accumulation of dust. When inspecting or changing the oil, move the machine to a place that is free of dust to prevent dirt from getting into the oil. AVOID MIXING OIL Never mix different kinds of oil. If a different type of oil has to be added, drain the old oil and replace all the oil with the new type of oil. LOCKING INSPECTION COVERS Lock inspection cover in position securely with a lock bar.
If inspection or maintenance is performed with the inspection cover open and not locked in position, there is a hazard that it may be suddenly blown shut by the wind and cause injury to the worker. BLEEDING AIR FROM HYDRAULIC CIRCUIT If the hydraulic oil equipment has been repaired or replaced and if the hydraulic hoses, pipes, etc. have been disconnected, it is necessary to bleed air in the circuit. See “CHANGE HYDRAULIC OIL, REPLACE HYDRAULIC OIL FILTER ELEMENT” on page 3-57. PRECAUTIONS WHEN INSTALLING HYDRAULIC HOSES When removing parts at locations where there are O-rings or gasket seals, clean the mounting surface, and replace with new parts.
When doing this, be careful not to forget to assemble the O-rings and gaskets. When installing the hoses, do not twist them or bend them into loops with a small radius. This action will cause damage to the hose and markedly reduce its service life. WA480-5L 3-3