MAINTENANCE ENGINE ( ): Always contact your Komatsu distributor when dealing with these items. In cases of abnormalities or causes which are not listed below, please contact your Komatsu distributor for repairs. 3-10 WA480-5L Problem Main causes Remedy Engine oil pressure caution pilot lamp lights up Engine oil pan oil level is low (suck- ing in air) Clogged oil filter cartridge Defective tightening of oil pipe joint, oil leakage from damaged part Defective monitor Add oil to specified level, see “PRE- OPERATIONAL CHECKS” on page 2- 78. Replace cartridge, see “EVERY 500 HOURS SERVICE” on page 3-50.
(• Check, repair) (• Replace) Steam is emitted from top part of radiator (pressure valve) Water temperature gauge is in red range Coolant temperature monitor lights up Cooling water level low, water leak- age Defective fan pump or motor Dirt or scale accumulated in cooling system (cooling fan in reverse) Clogged radiator fin or damaged fin Defective thermostat Defective thermostat seal Loose radiator filler cap (high altitude operation) Defective monitor Check, add cooling water, repair, see “GENERAL MAINTENANCE AND INSPECTION” on page 3-25. (• Check, repair) Change cooling water, clean inside of cooling system, see “GENERAL MAIN- TENANCE AND INSPECTION” on page 3-25.
Clean or repair, see “GEN- ERAL MAINTENANCE AND INSPEC- TION” on page 3-25. Set cooling fan to “FORWARD” (• Replace thermostat) (• Replace thermostat seal) Tighten cap or replace packing (• Replace) Water temperature gauge is in white range on left Defective thermostat Defective monitor (• Replace thermostat) (• Replace) Engine does not start when starting motor is turned Lack of fuel Air in fuel system No fuel in fuel filter Defective supply pump or injector Starting motor cranks engine too slowly Starting motor does not turn Preheating pilot lamp does not light up Defective valve clearance (Defective compression) Add fuel, see “START-UP PROCE- DURES” on page 2-83.
Repair place where air is sucked in. Fuel filter with fuel. See “EVERY 500 HOURS SERVICE” on page 3-50 (• Replace pump or injector) See “ELECTRICAL SYSTEM” on page 3-5 See “ELECTRICAL SYSTEM” on page 3-5 See “ELECTRICAL SYSTEM” on page 3-5 (• Adjust valve clearance) Exhaust gas is white or blue Too much oil in oil pan Improper fuel Add oil to specified level, see “START-UP PROCEDURES” on page 2-83. Change to specified fuel