Komatsu — TORQUE LIST

MAINTENANCE STANDARD TIGHTENING TORQUES FOR FASTNERS AND HOSES TORQUE LIST If nuts, bolts, or other parts are not tightened to the specified torque, looseness or damage to the tightened parts, which will cause machine failure or problems with operation. Always pay careful attention when tightening parts. Unless otherwise specified, tighten the metric nuts and bolts to the torque shown in the table below. The tightening torque is determined by the width across the flats of the nut and bolt. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced. Use the following table for Hydraulic Hose.

WA480-5L 3-21 Thread diameter a(mm) Width across flat b(mm) Tightening torque Target value Service limit N•m lbft N•m lbft 6 10 13.2 9.8 11.8 - 14.7 8.7 - 10.8 8 13 31 23.1 27 - 34 20.3 - 25.3 10 17 66 48.5 59 - 74 43.4 - 54.2 12 19 11 83.2 98 - 123 72.3 - 90.4 14 22 177 130.2 157 - 196 115.7 - 144.7 16 24 279 206.1 245 - 309 180.8 - 227.8 18 27 382 282.1 343 - 425 253.2 - 314.6 20 30 549 405.0 490 - 608 361.7 - 448.4 22 32 745 549.7 662 - 829 488.2 - 611.2 24 36 927 683.5 824 - 1030 607.6 - 759.5 27 41 1320 976.5 1180 - 1470 868.0 - 1085.0 30 46 1720 1265.8 1520 - 1910 1121.1 - 1410.4 33 50 2210 1627.4 1960 - 2450 1446.6 - 1808.3 36 55 2750 2025.2 2450 - 3040 1808.3 - 2242.2 39 60 3280 2423.1 2890 - 3630 2133.7 - 2676.2 Thread diameter a(mm) Width across flat b(mm) Tightening torque Target value Service limit N•m lbft N•m lbft 14 19 29.4 21.7 27.5 - 39.2 20.3 - 28.9 18 24 78.5 57.3 58.8 - 98.1 43.4 - 72.3 22 27 117.7 86.8 88.3 - 137.3 65.1 - 101.3 24 32 147.1 108.5 117.7 - 176.5 86.8 - 130.2 30 36 215.7 159.1 176.5 - 245.2 130.2 - 180.8 33 41 255.0 188.1 215.7 - 284.4 159.1 - 209.8