MAINTENANCE LUBRICATING POINTS 1. Using a grease pump, pump in the grease through the grease fittings marked by the arrows. 2. After greasing, wipe off any old grease that was pushed out. Center hinge pin (2 points). 3. Drive shaft center support (1 point). CHECKING PARTS OF TURBOCHARGER Please contact your Komatsu distributor to have the tightening portions checked. CHECK PLAY OF TURBOCHARGER ROTOR Please contact your Komatsu distributor to have the rotor play checked. REPLACE CORROSION RESISTOR CARTRIDGE 1. Set 2 levers (1) at the top of the corrosion resistor to the side to the CLOSED position. 2. Using a filter wrench, turn cartridge (2) to the left to remove it. 3.
Apply engine oil to the sealing surface of a new cartridge, then install it to the filter holder. 4. Bring the packing surface into contact with the seal surface of the filter holder, then tighten an additional 2/3 turn. 5. Set 2 levers (1) vertically to the OPEN position. 3-56 WA480-5L