OPTIONS, ATTACHMENTS 6. Check the display for the selected material on load meter display (1). The present selection display is A. In the case of the addition mode, “TOTAL LOADED” is displayed on display (2). 7. If A is to remain selected, press the ( „ ) of monitor panel mode selector switch 1. A is then selected. If A is to be changed to B to E, press the (>) or ( type of material, then press the ( „ ) of monitor panel mode selector switch 1. 8. This completes the setting of the addition mode. The character dis- play returns to the normal service meter and time display.
Once the setting has been made, even if the starting switch is turned OFF and operations are stopped, the setting is retained. When oper- ations are started again, there is no need to perform the setting again. All further loads will be added to the total load recorded before operations were stopped. SETTING THE REMAIN MODE When performing operations in the remain mode, set to the remain mode. For details of the remain mode functions, see “SUBTRACTION FUNCTION” on page 5-15. 1. Check that the normal service meter and time are displayed on the character display. 2. Press the ( ‘ ) of monitor panel selector switch 1 and display “LOAD METER”. 3.
Press the ( ‘ ) of monitor panel selector switch 1 and display “REMAINS MODE”. Remark If the previous setting was the addition mode, “ADDITION MODE” is displayed; if the previous setting was the remain mode, “REMAINS MODE” is displayed. 5-8 WA480-5L