OPERATION 16.3.2 PRECAUTIONS FOR CHARGING BATTERY CHARGING BATTERY WHEN MOUNTED ON MACHINE ! Before charging, disconnect the cable from the negative (-) terminal of the battery. Otherwise, an unusually high voltage could damage the alternator. ! While charging the battery, remove all battery plugs for satisfactory ventilation. To avoid gas explosions, do not bring fire or sparks near the battery. ! If the electrolyte temperature exceeds 45 E C, stop charging for a while. ! Turn off the charger as soon as the battery is charged. Over charging the battery may cause the following: 1) Overheating the battery 2) decreasing the quantity of electrolyte 3) Damaging the electrode plate !
Do not mix the cables ( positive (+) to negative (-) or negative (-) to positive (+) ), as this could damage the alternator. ! When performing any service to the battery besides checking the electrolyte level or measuring the specific gravity, disconnect cables from the battery. REMARKS: The batteries are on both sides at the rear of the machine. The battery used for the ground is on the left side of the machine. 2-72