OPERATION 16.4.3 ENGINE ! ( ): Always contact your distributor when dealing with these items. ! In cases of abnormalities or causes which are not listed below, please contact your distributor for repairs. 2-79 Problem Main causes Remedy Engine oil pressure caution pilot lamp lights up ! Engine oil pan oil level is low (sucking in air) ! Clogged oil filter cartridge ! Defective tightening of oil pipe joint, oil leaks from damage parts ! Defective eng oil presure sensor ! Add oil, see 12.2.3 CHECK OIL LEVEL, ADD OIL. ! Replace cartridge, see 24.6.1 CHANGE OIL, REPLACE OIL FILTER. (! Check, repair) (!
Replace sensor) Steam is emitted from top part of radiator (pressure valve) Water temperature gauge is in red range coolant temperature monitor lights up ! Cooling water level low, water leakage ! Loosen fan belt ! Dirt or scale accumulated in cooling system ! Clogged radiator fin or damaged fin ! Defective thermostat ! Loose radiator filler cap (high altitude operation) ! Defective water level sensor ! Add coolant, repair, see 12.2.1 CHECK BEFORE STARTING. ! Adjust fan belt tension, see 24.8.6 CHECK FAN BELT TENSION. ! Change cooling water, clean inside of cooling system, see 24.9.1COOLING SYSTEM, REPLACE COOLANT AND FLUSH SYSTEM. ! Clean or repair, see 24.2.5 CLEAN THE RADIATOR CORE. !
Replace thermostat ! Tighten cap or replace packing ! Replace sensor Water temperature gauge is in the white range on left ! Defective thermostat ! Defective monitor (! Replace thermostat) (! Replace) Engine does not start when starting motor is turned ! Lack of fuel ! Air in fuel system ! Defective fuel injection pump or nozzle ! Starting motor cranks sluggishly ! Preheating pilot lamp does not light up !Defective compression Defective valve clearance ! Add fuel, see 12.2.2 CHECK FUEL LEVEL ,ADD FUE. ! Repair place where air is sucked in, see 24.7.1 REPLACE FUEL FILTER. ! Replace pump or nozzle See ELECTRICAL SYSTEM See ELECTRICAL SYSTEM Adjust valve clearance Exhaust is white or blue !
Too much oil in oil pan ! Improper fuel ! Add oil to specified level. See 12.2.3 CHECK OIL LEVEL, ADD OIL. ! Change to specified fuel