Komatsu — 24.2.1 CHECK, CLEAN OR REPLACE AIR CLEANER ELEMENT

MAINTENANCE 24.2 WHEN REQUIRED 24.2.1 CHECK, CLEAN OR REPLACE AIR CLEANER ELEMENT WARNING ! Never clean or replace the air cleaner element with the engine running. ! When using pressurized air to clean the element wear safety glasses or goggles to protect the eyes. CHECKING Whenever the red piston in the dust indicator (1) appears, clean the air cleaner element. Cleaning or replacing outer element 1. Remove wing nut (2), and cover (3), take out outer element. 2. Clean the inside of the air cleaner body. 3. Direct dry compressed air (less than 700 kPa (7 kg/cm , 100 psi)) to 2 element from inside along its folds, then direct it from outside along its folds and again from inside.

1) Remove one seal from the outer element whenever the outer element has been cleaned. 2) Replace the outer element which has been cleaned 6 times repeatedly or used throughout a year. Replace the inner element at the same time. 3) If the dust indicator display red immediately after the outer element has been cleaned, replace both inner and outer elements, even if the outer element has not been cleaned 6 times. 4) Check inner element mounting nuts (4) for looseness and, if necessary, re-tighten. (Torque to 5.4 ± 0.5 Nm (0.55 ± 0.05 kgm) 5) Replace seal washer or wing nut with new parts if they are broken.

(Torque to 5.4 ± 0.5 Nm (0.55 ± 0.05 kgm) 6) Remove evacuator valve (6) and clean with compressed air. After cleaning, install it back to it’s proper position. NOTE: After cleaning and drying the element, then check it by shining a light through it, if any small holes or thin cracks are found, then replace the element. When cleaning the element, do not hit it or beat it against anything. Do not use an element that has any damaged folds, gaskets or seals. 3-31