Komatsu — 24.2.5 CLEAN RADIATOR FINS

MAINTENANCE 24.2.4 CLEAN THE AXLE CASE BREATHER WARNING ! When cleaning the axle case breathers, apply the parking brake and lock the front and rear frames with the safety bar and pin. There are two breathers to clean, one on the front axle and one on the rear Remove all mud and dirt from around the breather with a brush. 24.2.5 CLEAN RADIATOR FINS Carry out this procedure if there is any dirt, mud, leaves etc. stuck to the radiator. 1. Open the rear grill at the rear of the machine. 2. Use compressed air to clean and remove the dirt and leaves from the radiator fins. Steam or water may be used instead if compressed air.

When using steam, the radiator fins could get damaged if the steam nozzle gets too close to the fins, so keep the nozzle well away from the fins. NOTE: Also! This is a good time to check the hoses. See if any hoses show cracks or hardness due to ageing and if any of the clamps are loose. 3-35