MAINTENANCE 24.2.7 REPLACE BUCKET TEETH (IF EQUIPPED) WARNING It is extremely dangerous if the work equipment moves when performing this procedure. Set the work equipment in a stable position, turn off the engine, then set the safety lock for the work equipment control lever securely to the LOCK position. When the bucket teeth are worn then replace them as follows. 1. Raise the bucket to a suitable height, then Position the bucket so that the bottom surface of the bucket is horizontal and put blocks under it to prevent it from coming down. 2. Remove nuts and bolts (1) and (2) then remove the teeth (3). 3. Clean the mounting surface of the bucket teeth.
If the mounting surface is worn then repair and correct it before installing new teeth. 4. Install new teeth and use shims to eliminate any clearance between the teeth and the top surface of the bucket. Minimum clearance should be less then one shim thickness 0.5 mm (0.02 in) 5. To prevent any gap from occurring between the tooth and the tip of the bucket, slightly tighten the hardware (temporarily) then hit the tip of the tooth with a hammer. Torque for mounting bolts: 461 ± 69 N C m (47 ± 7 kgm, 340 ± 51 lbf ft) 6. Re-torque the mounting bolts again after operating the equipment for several hours. 3-37