Komatsu — 24.2.11 ADJUST PARKING BRAKE

MAINTENANCE 24.2.11 ADJUST PARKING BRAKE the parking brake is a sealed wet type disc brake, so the brake itself does not need adjusting. However, if the travel of the brake pedal increases because of looseness of the control cable mount or elongation of the control cable, adjust as follows. CHECKING Depress the parking brake pedal with a force of approximately 30 kg (66 lb). If the travel of the brake pedal is more than 13 clicks, check for looseness of control cable mount (pedal and brake end). If any looseness is found, tighten and adjust as follows.

ADJUSTING WARNING Prior to adjusting, always block the tires to prevent the machine from moving and LOCK the front and rear frame with the safety bar. 1. Pull release lever (1) and release the parking brake. 2. Loosen lockout (2) and remove clevis pin (4). 3. Pull lever (5) at the parking brake end fully to release the brake and set it in the release position. 4. Screw in clevis (3), align the pin with the pin hole in lever (5) at the parking brake end, then assemble the clevis pin (4) and tighten lockout (2). After adjusting, depress parking brake pedal (6) with a force of approximately 30 kg (66 lb), and check that the travel of the pedal is 7 - 11 clicks. 3-40