Komatsu — 24.6.3 CLEAN ELEMENT IN AIR CONDITIONER RECIRCULATION FILTER

MAINTENANCE 11. Close the engine hoods. Ъ Diluted oil can cause severe damage to the engine. Check the condition of the used oil. ! Thin, black oil indicates fuel dilution. ! Milky discoloration indicates coolant dilution. If you notice any excessive metal particles or foreign material then consult your distributor. 24.6.2 CHECK FOR LOOSE WHEEL BOLTS. TIGHTEN If wheel bolts (1) are loose, tire wear will be increased and accidents could happen. If any nuts are loose, tighten them to the specified torque. Torque: 927 ± 103 Nm (94.5 ± 10.5 kgm, 684 ± 76 lbf ft) If any stud is broken, replace all studs for that wheel. Always rotate in the direction of tightening when checking for loose bolts.

24.6.3 CLEAN ELEMENT IN AIR CONDITIONER RECIRCULATION FILTER 1. Open the filter inspection cover, remove the filter cover, then remove the filter in the direction of the arrow. When removing the filter to the side, put your weight on the seat, and push down. 2. Direct compressed air (less than 7 kg/cm [100 psi / 689 kPa]) to the filter 2 from the inside along its folds, then direct it from the outside along its folds and again from the inside. Check the filter for damage and/or deterioration. If the filter is extremely dirty, rinse it in water. After rinsing the filter, dry it completely before installing it again. 3-48