OPTIONS, ATTACHMENTS 27. HEATER AND AIR CONDITIONING (IF EQUIPPED) 27.1 GENERAL LOCATION AND FUNCTION OF CONTROL PANEL 1. Press the "ON/OFF" square and light (1) and the "TEMPERATURE SETTING" will light up to indicate ON mode, press it again and the light will go out to indicate OFF mode. 2. Press "ARROW UP" (2) to increase the temperature setting, press "ARROW DOWN" (3) to decrease the temperature setting 3. Press the "FAN" square to turn the fan ON and the fan speed light bar graph will light up to indicate fan speed, press it again and the light will go out to indicate OFF mode. 3.
Press "ARROW UP" (4) to increase fan speed and the light on the bar graph will go up, press "ARROW DOWN" (5) to decrease the fan speed and the light on the bar graph will go down. 4. Press square (6) for defroster mode and light (7) will light up and the fan speed will automatically jump to maximum high, press it again and the light will go out to indicate OFF mode. This feature causes the controller to cycle every 3 minutes, with the heat valve open, to remove humidity from the cab. The heat valve is cycled normally, during 3 minutes intervals, to maintain temperature set point. When activated the fan automatically increases to highest position. The fans can then be adjusted down and up.
After deactivating defrost. the fans will return to the position set before activation. 5. Defroster (6), up arrow (2), and down arrow (3) when pressed simultaneously it will toggle the temperature units between FAHRENHEIT and CELSIUS. 5-4