Komatsu — Komatsu PC290NLC-6K and PC290LC-6K Hydraulic Excavator Operation & Maintenance Manual

13. TRANSPORTATION 13.3 PRECAUTIONS FOR TRANSPORTATION Lifting point Lifting a machine must be performed on a flat place with the following procedure. (1) Start the engine and set the machine in the position shown in the figure at the right (boom at the top stroke and, arm bucket fully re- tracted). Direct the top revolving super-structure straight forward (idler side). 1.1 m or more 20° or less 3 m or more 33° or less (2) Set the safety lock lever in the lock position. (3) Stop the engine. Confirm safety around the operator seat. Get off the vehicle. Be sure to close the cab door, windshield, right and left doors, engine hood, etc.

(4) Mount a shackles to the lifting hooks on the boom and the counter weight. Hang the wire rope. (5) The length of the wire rope and the lifting angle must be as shown in the figure at the right. (6) When lifting, make sure that there is no change in position due to pos- sible leakage in the hydraulic circuit on the boom cylinder head side. (7) When the machine leaves the ground, stop the machine and make sure sufficiently that the machine is balanced. Then, lift the machine slowly. PC290-ENG 2-86 WARNING • Determine the route for transporting the machine by taking into account the width, height and weight of the machine.

• Always check that the door on the cab is closed and locked before transporting the machine. WARNING Obey all state and local laws governing the weight, width and length of a load. Observe all regulations governing wide loads. 13.4 LIFTING THE MACHINE How to lift a machine Personnel who perform lifting using a crane must be qualified. PRECAUTION Contact your distributor to get an instruction of lifting a ma- chine. Some parts are required and available as optional parts. WARNING • Do not lift a machine with personnel in it. • The rope used for lifting must have sufficient strength to with- stand the weight of this machine.

• The machine must not be in a position other than that shown in the following procedure when lifting a vehicle. Otherwise, the machine may be unbalanced. WARNING