Komatsu — Komatsu PC290NLC-6K and PC290LC-6K Hydraulic Excavator Operation & Maintenance Manual

20. USE FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE REMARK We recommend Komatsu genuine lubricants (Spectrum XXX) oil which has been specifically formulated and approved for use in engine and hydraulic work equipment applications. (See reference table on page 3-14) Only use high quality oils wich meet internationally recognised specifications. When starting the engine in an atmospheric temperature of lower than 0 o C, be sure to use engine oil of SAE10W, SAE10W-30, SAE15W-40 and synthetic 5W-30, even though an atmospheric temperature goes up to 10 o C more or less in the day time.

Use API classification CE or CF-4 as engine oil and if API classification CD, reduce the engine oil change interval to half. There is no problem if single grade oil is mixed with multigrade oil (SAE1OW-30, 15W-40), but be sure to add single grade oil that matches the temperature in the table. When fuel sulphur content is less than 0.5%, change oil in the oil pan every periodic maintenance hours described in this manual. Change oil according to the following table if fuel sulphur content is above 0.5%. Specified capacity: Total amount of oil including oil for components and oil in piping. Refill capacity: Amount of oil needed to refill system during normal inspection and maintenance.

Abbreviations : ASTM: American Society of Testing and Material SAE: Society of Automotive Engineers API: American Petroleum Institute If an engine is operated in ambient temporatures consistently below -23°C (-10°F) and there are no provisions to keep the engine warm when it is not in operation use a synthetic API performance classification CE or CF- 4 engine oil with adequate low temperature properties such as SAE SW-20 or 5W-30. The oil supplier must be responsible for meeting the performatic service specifications. NOTICE The use of a synthetic base oil does not justify extended oil change intervals.

Extended oil chance intervals can derease engine life doe to factors such as corrosion deposits and wear. PC290-ENG 3-13 Fuel sulphur content I Change interval of oil in engine oil pan 0.5 to 1.0% 1/2 of regular interval 1.0% to 1.5% 1/4 of regular interval