24. SERVICE PROCEDURE 24.1.17 REPLACE BUCKET SIDE CUTTERS A WARNING It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the levers. 1. Untighten nuts G) and bolts @) and remove side cutters @ and @. 2. Clean cutter mounting face on bucket side plate. 3. Check nuts and bolts and replace if damaged. 4. Fit new side cutters. 5. Tighten bolts to 110 + 10 kgm. 3-36 PC160/180/200-6k-ENG NOTICE When side cutters are not being used shrouds @ should be fitted to prevent wear of the bucket side plate.