hitachi — 850.indb

ASSEMBLING INSTALLING BOOM CYLINDER IMPORTANT: Take care not to mix up the right and left cyl- inders. Install the cylinder with the cylinder piping positioned downward. 1. Pull out the boom foot pin (2) until the end of the pin is flush with the inside end of the bracket. 2. Apply a film of grease to pin (2). 3. Lift up left-hand boom cylinder (3) with a crane. WARNING: • When aligning the centers of the pin and pin hole, never put fingers into the pin hole. • When using a hammer, wear safety equipment such as safety glasses or a hard hat to protect against injury from flying pieces of metal. • When inserting the pin, never enter into the area under the boom cylinder. 4.

Align the boom cylinder bottom hole with the boss hole on the frame. Measure clearance “a.” If clearance “a” is 4 mm (0.16 in) or more, remove the shim on the pin and install it , as illustrated. 2 Bracket Bracket M116-07-025 Shim Pin Boss of Main Frame Side 5. Align pin hole (4) on the bottom side of the boom cylin- der with pin hole (5) on the main frame to drive pin (2) in. Take care not to damage the seal at this time. Clearance (a) Boss of Bottom Side of Boom Cylinder M1J1-06-017 6. Tighten bolt (6) to secure pin lock plate (1). Tightening torque: 400 N•m (40 kgf•m, 290 lbf•ft) 3 4 5 M116-07-026 1 6 M116-07-027 6-6