hitachi — 850.indb

TRANSPORTING Unloading WARNING: The rear end of the flatbed where it meets the ramp is a sudden bump. Take care when traveling over it. IMPORTANT: Prevent possible damage to the front attach- ment. Always position the arm at 90° to the boom when unloading the machine. Unload- ing the machine with the arm tucked in may cause machine damage. 1. To move the machine over end of the trailer onto the ramp, rest the flat surface of the tip of arm on the ground. Angle of the arm to the boom should be 90 to 110°. IMPORTANT: Prevent possible damage to the hydraulic cylinders. Do not allow the machine to hit the ground hard with the arm. 90 to 110° 2.

The tip of arm must be on the ground before the ma- chine begins to tip forward. 3. As the machine moves forward, raise the boom and extend the arm until the machine is completely off the ramp. M111-06-034 M111-06-035 6-19