hitachi — 850.indb

TRANSPORTING EXTENDING THE SIDE FRAME Required Tools • Slinging Rope (20 mm dia.Ч8 m, 6Ч37 Ordinary Z lay Class A, Applicable Max. Load: 3 tons) .....................................................................................................6 Used * Before slinging, make sure no broken wire strands and/ or kinks exist. • Lever Block (JIS B8819 equivalent to L3.2T) .....................................................................................................2 Used * Check that there is no damage on the lever block. • Power Boost Wrench (including accessories), width across flats of the torque wrench: 50 mm • Air Compressor (slide surface cleaning) • Soft Protectors 1 3 2 WARNING:

• Group work is required. Before starting work, coor- dinate work procedures with co-workers. • Damage to the lever block and/or wire rope may result along with severe personal injury. When ex- tending the side fame using the front attachment, do not allow any personnel to enter the vicinity of the machine. 1 9 M162-06-001 WARNING: Do not loosen side frame guide bolts (9). IMPORTANT: When the machine is shipped from the fac- tory, all side frame tightening bolts are not installed. Therefore, unbolted screw holes on the side frame are coated with rust-inhib- itor so that they may be clogged with dust or soil. Before installing the tightening bolts, clean the thread surface thoroughly.

If the bolts are difficult to tighten, tap the screw holes again. Tap: M36, Pitch: 3 mm 90 to 110° IMPORTANT: Before working, completely clean the side frame slide surfaces using compressed air. If mud and/or gravel is stuck on the contact ar- eas of track frame (2) and side frame (3), the work may be interrupted and loose mount- ing bolts (1) may result. M166-01-233 1. Remove side frame mounting bolts (1) (8 used, 4 bolts in two places) from the extending side frame. 2. Rotate the upper structure to the side of the extending side frame until the front attachment faces the side frame perpendicularly. 3. Set the arm and boom angle between 90° to 110°.

Then, lower the bucket bottom to the ground. 6-22