Transmissions With Park Position With Auto-Apply Parking Brake 1. Bring the vehicle to a complete stop using the ser- vice brake. 1. Bring the vehicle to a complete stop using the ser- vice brake. 2. Ensure that the engine is at low idle rpm. 3. Put the transmission in P (park). 2. Ensure that the engine is at low idle rpm. 3. Put the transmission in PB (auto-apply parking brake). 4. Apply the parking brake (if equipped), and make sure it is properly engaged. 4. Apply the emergency brake (if equipped), and make sure it is properly engaged. 5. Engage the park range by slowly releasing the ser- vice brake. 5.
Chock the rear tires and take any other steps nec- essary to keep the vehicle from moving. 6. Apply the emergency brake (if equipped), and make sure it is properly engaged. 7. Chock the rear tires and take any other steps nec- essary to keep the vehicle from moving. 2400 Series On vehicles with 2400 series transmissions, follow the instructions for vehicles with 1000 series transmissions. 2000 Series 1. Bring the vehicle to a complete stop using the ser- vice brake. On vehicles with Allison 2000 series transmissions, do the following steps if you have to leave the cab with the engine running (for example, when checking the trans- mission fluid): 2. Ensure that the engine is at low idle rpm.
3. Put the transmission in P (park). Without Auto-Apply Parking Brake 4. Apply the parking brake (if equipped), and make sure it is properly engaged. Follow the instructions for vehicles with 1000 series transmissions, under the heading "Without Park Posi- tion." 5. Engage the park range by slowly releasing the ser- vice brake. 5.30