Freightliner Business Class — Business Class Driver's Manual

Transmissions 3 and 2 (Third and Second Ranges, standard) NOTE: Each time a push button is depressed on the shift selector, a short beep will be heard. This indicates that the ECU has received input to change operation. Use the third or second range for heavy city traffic and for braking on steeper downgrades. 1 (First Range) The MD-series transmission system is designed to warn the driver of transmission malfunctions. The driver of a vehicle equipped with these transmissions should know the extent of the warning system in order to safely oper- ate the vehicle. See Chapter 3 for information on the warning system.

Use first range when pulling through mud or deep snow, when maneuvering in tight spaces, or when driving up or down very steep grades. First range provides the vehicle with its maximum driving torque and maximum engine braking effect. General Information, MD Series Safety Precautions, MD Series MD-series automatic transmissions have six forward speeds and one reverse speed. See Fig. 5.18 . These transmissions have electronic shift controls that can be programmed to allow the use of different numbers of geared speeds. For instance, the transmission can be programmed to operate as a four-speed, five-speed, or six-speed unit in the "primary" shift mode.

If needed, a "secondary" shift mode can be programmed to provide another shift configuration to optimize vehicle use under different operating conditions. To activate a secondary shift mode, or other special function programmed into the electronic control unit (ECU), depress the mode but- ton. "Mode On" is displayed in the indicator panel just above the push buttons. A label just above the Mode button identifies the special function. WARNING Do not leave the vehicle unattended with the engine running. If you leave the vehicle and the engine is running, the vehicle can move suddenly, which could result in personal injury or property damage.

On vehicles with MD series transmissions, do the fol- lowing steps if you have to leave the cab with the en- gine running (for example, when checking the transmis- sion fluid): 1. Bring the vehicle to a complete stop using the ser- vice brake. 2. Put the transmission in N (neutral). 5.34