Freightliner Business Class — Business Class Driver's Manual

Clutches, Rear Axles, and Steering action where traction is good. When one wheel begins to spin faster than the other, clutch plates in the differ- ential housing automatically engage, delivering power to both wheels. There is no operator control with this fea- ture. Fig. 6.2 . After the vehicle is moving on the highway, the axle can be shifted to high range. A traction equalizer occasionally tends to slip in a jerk- ing motion, producing irregular intervals of sharp noises. This generally occurs when the vehicle is operating at low speeds on fairly sharp turns. This condition, called slip-stick, is corrected by adding a friction modifier to the axle lubricant.

This additive tends to reduce the static coefficient of friction to a value equal to, or lower than, the sliding coefficient. B A 10/31/94 f600370a A. Push down for low speed range. B. Pull up for high speed range. See Group 35 of the Business Class ® Trucks Mainte- nance Manual for additional information on friction modifiers and when to add them to axle lubricants. Fig. 6.2, Range Selection Lever Operation CAUTION To shift the axle to the high range: keep the throttle pedal down, then move the range selection lever to high; release the throttle pedal until the axle shifts, then accelerate. Tire sizes on both rear wheels should be the same on axles equipped with a traction equalizer.

If not, excessive wear may occur in the traction equalizer. To shift the axle to low range: keep the throttle pedal down, then move the range selection lever to low; re- lease and then depress the throttle pedal quickly to in- crease engine rpm. The axle will shift to low range. Meritor Two-Speed Rear Axle The two-speed rear axle can be used to operate the vehicle in low range when operating off-highway or when starting out with a heavy load on-highway. See NOTE: When parking the vehicle, put the axle in the low range with the engine running. Engage the clutch and transmission to be sure the axle has 6.5