Pretrip Inspection and Daily Maintenance Observe the level of the wheel bearing lubricant in the hub cap at each end of the front axle and if needed, fill the hubs to the level indicated on the hub cap. See Group 33 of the Business Class ® Trucks Maintenance Manual for recommended lubri- cants. 1 IMPORTANT: Before removing the fill plug, always clean the hub cap and plug. 5. Tilt the hood. Examine the steering gear compo- nents. 2 1 Examine the steering gear mounting bolts ( Fig. 9.2 ), pitman arm nut, and the drag link nuts for tightness. Be sure that the steering driveline and the U-joints are in roadworthy condition, without cracks, breaks, looseness, or other damage.
Tighten loose nuts, and replace damaged parts as needed. See Group 46 of the Business Class ® Trucks Service Manual. 1 NOTE: On right-hand-drive vehicles, a linkage sys- tem runs from the steering driveline to the steering gear on the left-hand frame rail. 10/05/94 1. Steering Gear Mounting Bolts 2. Pitman Arm Pinch Bolt Nut f460512b 6. Check the power steering hoses for chafing. Check for leakage around the fittings. Replace any damaged hoses and tighten all fittings to stop leak- age. Fig. 9.2, Steering Gear (TAS series shown) 9.6