Pretrip Inspection and Daily Maintenance 20.1 To keep condensation to a minimum, fill the fuel tanks at the end of each day, but not to more than 95 percent of liquid capacity. Se- lect the proper grade of fuel as specified by the engine manufacturer. IMPORTANT: Before doing any of the following procedures, make sure that there is an ad- equate amount of fuel in the tank(s). Do not fill the tank(s) to more than 95 percent of liquid capacity. WARNING 20.4 On vehicles equipped with a single tank, prime the fuel system if needed. On vehicles with dual tanks, go to the next substep. Do not mix gasoline or alcohol with diesel fuel. This mixture could cause an explosion.
When filling fuel tanks, do not smoke or use an open flame near the fuel tanks; combustion of diesel fuel oil or fuel va- pors could result. If the engine is equipped with a priming pump, do the following: Unlock and operate the engine’s priming pump plunger until resistance is felt. 20.2 Always strain or filter fuel before putting it into the tanks. This will lengthen the life of the engine fuel filter and reduce the chances of dirt entering the engine. Push the plunger in and tighten it by hand. Start the engine. If it doesn’t start, more priming is needed. Once the engine has started it may run rough. If this occurs, run the engine at low idle until it runs smoothly.
20.3 Before installing the fuel cap, check the vent line for debris. Clean the area around the fuel tank cap with a rag, or if necessary, clean the cap with solvent. If the engine is not equipped with a priming pump, do the following: CAUTION Remove the fuel tank cap. Don’t crank the engine for more than 30 seconds at a time during any of the following procedures. Wait two minutes after each try to allow the starter to cool. Failure to do so could cause starter damage. Loosen the fuel supply line at the fuel trans- fer pump. Partially cover the fuel tank opening with your hand. Using an air hose, apply no more 9.13