Pretrip Inspection and Daily Maintenance 40.3 Do not route the hose on top of anything likely to be stepped on or walked on. dius values, see Group 42 of the Business Class ® Trucks Service Manual. 40.4 Check for damage to hoses located near moving parts, such as drivelines, trailer bod- ies, kingpins, suspensions, and axles. If the moving parts are catching or pinching the lines, correct as needed. When a rubber hose does not meet mini- mum bend radius requirements, the outside may appear smooth even if the inner tube is kinked. Reroute the hose or replace it with one of adequate length if the bend radius is not within minimum specifications. 40.5 Check for hose damage caused by abrasion.
If a hose is abraded, replace it. Check for the cause of abrasion, such as loose or damaged hose clamps. Repair or replace the clamps as needed. 40.6 Observe the hose cover condition, especially hoses exposed to water splash and ice. If any hose is dried out or ragged (the wire or liner is showing through the cover), replace the hose. 11/03/94 f420329a A 40.7 Inspect air tubing, especially tubing made of nylon. In cold weather, nylon tubing is sensi- tive to damage, such as nicks or cuts. Re- place nicked or cut tubing, even if it is not leaking. NOTE: Center of the hose bend radius should be well away from the fitting. A. Bend Radius Fig.
9.12, Bend Radius 40.8 Check the bend radii of all hoses. See Fig. 9.12 . The minimum bend radius of a hose is that bend which the hose will with- stand without experiencing damaging stresses or kinking. For minimum bend ra- 40.9 Check straight hose installations (those hoses that do not bend along their routings). Pressure changes can cause a hose to lengthen up to two percent or shorten up to 9.23