Freightliner Business Class — Business Class Driver's Manual

Pretrip Inspection and Daily Maintenance NOTE: If unable to accurately measure the brake lining, remove the wheel and hub as- sembly for a thorough inspection. IMPORTANT: The load and cold inflation pres- sure must not exceed the rim or wheel manu- facturer’s recommendations, even though the tire may be approved for a higher load or infla- tion. Some rims and wheels are stamped with a maximum load and maximum cold inflation rating. See Group 40 of the Business Class ® Trucks Service Manual for the correct tire infla- tion pressure for the vehicle load or consult the rim or wheel manufacturer if they are not stamped.

If the load exceeds the maximum rim or wheel capacity, the load must be adjusted or reduced. 41.3 Measure the brake lining thickness. If any of the brake linings are worn to less than 1/4 inch (6.5 mm) at the thinnest point, replace the linings on all brake assemblies on that axle. NOTE: To replace the brake linings, see the applicable brake section in Group 42 of the Business Class ® Trucks Service Manual. 41.4 If removed, install the access plug. Remove the chocks from the tires. 43.1 Check the inflation pressures of the tires be- fore each trip using an accurate tire pres- sure gauge ( Fig. 9.13 ). Tires should be checked when cool.

See Table 9.1 or Table 9.2 for the correct tire inflation pres- sure for the vehicle load. When traveling at unusual speeds, use Table 9.3 to adjust tire pressure. Be sure that valve stem caps are on every tire and that they are screwed on finger-tight. Inflate the tires to the applicable pressures if needed. 42. Make sure that the brakes are adjusted on all ax- les. Adjust the brakes if necessary. See Group 42 of the Business Class ® Trucks Service Manual for checking and adjusting procedures. IMPORTANT: Brake checking and adjusting is nec- essary for all vehicles, including trucks equipped with automatic slack adjusters. 43.

Check the tire inflation pressures and inspect each tire for bulges, cracks, cuts, and penetrations. Check tire wear. Overinflation gives the treaded surface of the tire a convex shape ( Fig. 9.14 ). This causes extreme tire wear in the middle part 9.25