Driver Controls and Instruments will also change the second alert detection range from 2 to 1.75 seconds. Push and hold the knob for 5 seconds to activate the accident reconstruction function and freeze the most recent data in half of the allocated memory. Fault Codes (blink codes) Fault Code Suspect Failure 25 SmartCruise 31 J1587 32 J1939 33 VBUS 34 DDU Communications 35 Antenna Assembly Communications 41 No Fault or End of Fault Codes NOTE: The system may be configured to prevent adjustment of the range levels. 5. The red system failure indicator light illuminates if a system problem is detected. Press and hold the volume control knob for 5 seconds to display fault codes.
The fault codes will be blinked out as a pat- tern of flashes on this indicator light. See Table 3.3 for fault codes. Table 3.3, Fault Codes or Blink Codes 6. The green SC indicator light will flash 8 times if the range knob is pressed to store accident reconstruc- tion information. It will also flash 8 times after the system is activated, after the power-on LED test is finished, and if accident reconstruction data was previously stored. Fault Codes (blink codes) Fault Code Suspect Failure 11 Central Processing Unit (CPU) 12 CyberCard 13 Driver Display Unit (DDU) 14 Antenna Assembly 15 Right Side Sensor 16 Left Side Sensor 21 Right-Turn Signal 22 Left-Turn Signal 23 Brake 24 Speed 7.
The photo light sensor senses lighting conditions in the cab and automatically adjusts the intensity of the indicator and alert lights. 8. If the system’s configuration requires, insert the driver’s identification card in the slot at the lower front edge of the DDU. A high-pitched tone will sound when the driver’s identification card has been successfully read. One low tone will sound if the driver’s card has been unsuccessfully read. If so configured, a repeated low tone will sound if the 3.34