ENGINE MAINTENANCE - Maintenance Procedures How to Install a CCV Unit to the Engine Installation instructions for servicable Crankcase Ventilation (CCV) modules. death, personal injury, equipment or property damage. NOTE 2 Follow the steps below to install the CCV. 1. Install the CCV module on the engine. Tighten and torque the six bolts using a torque wrench to 16.2 +/- 1.5 lb-ft (22.0 +/- 2.0 N·m). 2. Attach electrical connector and inlet/outlet hoses. The engine and fuel module should be operated in cold climates with accepta- ble cold climate fuel blends which no- ticeably reduces wax gelling in the fuel filter cartridge.
The fuel module in- cludes a 12V preheater to support pre- heat of the fuel for initial start-up in mild climates. Failure to operate with acceptable cold climate fuel may result in insufficient fuel flow to the fuel injec- tion system. NOTE The fuel filter and the hand pump are located on the left-hand side of the en- gine, as viewed from the driver's seat. NOTE Fuel Filter Important information on replacing engine mounted cartridge type fuel filters. Use of poor quality fuel may require more frequent fuel filter element serv- ice. Biodiesel Perform these maintenance procedures according to the Preventative Maintenance Schedule.
Description NOTE The fuel filter/water separator module provides fine-particle filtration, water separation, water-in fuel-sensing, automatic water draining, lifetime purification of drained water with a charcoal filter, 12V preheating and system manual priming in a singular easy to service module. If B6-B20 biodiesel fuel is used, the fuel filter must be changed every 25,000 mi (40,000 km). WARNING When removing the fuel filter, a quanti- ty of fuel will escape. Do not smoke or allow an open flame in close proximity. Failure to do so could ignite a fire or cause an explosion which could result in serious injury to you and/or bystand- ers.
Failure to comply may result in 60 Y53-1166-1G1 (08/2018)