. OPERATION OPERATION OPERATION OPERATION 6. When the engine starts, release the key in starting switch (2). The key will return automatically to the ON position (B). REMARK Immediately after starting the engine, run at idle. While running the engine, release the decelerator pedal and do not operate the work equipment. Guideline for idle time Cold weather: At least 15 seconds 1st start after changing engine oil or engine oil filter: 20 seconds 3 - 95 2. Insert the key into starting switch (2) and turn the key to the ON position (B). 3. Chec k th at e ngine pre-heating pilot lamp (3) on the monitor p. key in the on position until the pre-heating pilot s off. monitor panel lights u p. 4.
Maintain the key in lamp (3) goe s off. n position unti 5. When preheating pilot lamp (3) goes off, turn the key of ignition switch (2) to the START po sition (C) to cr ank the engine. The ti me that preheating pilot lamp ( 3) stays on changes according to the ambient temper ature as show n in the table below. Ambient temperature Pre-heat time -5°C to -10°C (23°F to 14°F) 20 to 27 seconds -10°C to -20°C (14°F to -4°F) 27 to 40 seconds -20°C to -30°C (-4°F to -22°F) 40 seconds