. OPERATION OPERATION ADJUSTING POSTURE OF WORK EQUIPMENT WARNING BLADE ADJUSTMENT TILTING THE TILTDOZER cap at 4 mm 3 - 118 Whe n adjusting, it is da ngerous if the work equipment is moved by mistake. Set the work eq uipment in a saf e condition, t hen stop the e ngine and lock th e work equipment securely with the work equipment lock NOTICE 0 mm (29.6 in)for the EX specification machine and 500 mm (19.7 in)for the PX specification machine.
The maximum tilt is 75 0 mm (29.6 in)for the EX specific ation machine and 500 mm (19.7 in )for the PX specification mac Whe n tilting, make sur e that it does not exceed 750 m m (29.6 in)for the EX specification machine or 500 mm (19.7 in)fo r the PX specification machine. xceeded, excessive force will be brought to bear on all parts, and this will damage the machine. If th e maximum tilt is e xceeded, excessive force will be brought to bear on all parts, and t his will d amage the machine. If th e blade control l ever is operated, the followin be o btained. Rig ht side: 410 mm Left side:
410 mm (1 If m ore tilt is require Use bar handle (2) i nstalled to the left brace to tu change length (L) of the brace. This makes it po maximum tilt of 750 mm (29.6 in) for the EX spec and 500 mm (19.7 in ) for the PX specification ma S tandard distanc e between joints (L): 1287 m ADJUSTING SHIM IN BLADE CYLINDER CAP Set standard shim a 6 in). (0.1 Remove a shim as t he cap and cylinder securing Adequate clearance amount: 0.2 mm - 0.5 mm (0.