. OPERATION OPERATION ADJUSTING RIPPER REPLACING POINT AND PROTECTOR 3 - 121 ADJUSTING DIGG Mounting pin holes are provided in the shank an d these are u sed according to the desired di gging depth . For no rma use , use the bottom hole, and when particularly deep diggin g is needed, use the top hole. 1. Place a pointe d object on the ti p of pin ( hammer to rem ove from the opposite side. 2. Remove pin (2) and change the p osition of the shank ho 3. Insert pin (1) pa rtially by hand the n knock it in with a ha mmer.
The pin is m ade of one piece, hand then knock it in with a hammer To protect the shan are worn, replace th Place a pin remove r on the pin marke d by the a rrow, t hen h it with a hammer to remov e from the opposi and point installed to t REMARK The pin is a unitize d type, so insert th e pi n parti ally by hand , then knock it in fully with a hammer.