Komatsu — AFTER STORAGE

. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 137 BEFORE STORA GE g-term storage (more than one month), store as follows. When keeping in lon g-term storage (more than one month), store a Clean and wash al l parts, then store the machine indoors. If the machine has to be stored outdoors, sel ect level ground and cover the machine with a sheet. ing. on rods and the idler adjusting rods. Completely fill the fuel tank. This prevents moisture from collect Lubricate and cha nge the oil before storage.

Apply a thin coat o f grease to metal surface of the hydraulic pist on rods and the idler adjustin Disconnect the ne gative terminals of the battery and cover it or re move it from the machine and s tore it se parately. Place all control le vers in the neutral position, set the work equi pment lock lever and parking brake lev er in the LOCK position, an d set the fuel control dial to the low idling posi tion. To prevent rust, fill with Komatsu genuine supercoolant (AF-NAC ) to give a density of at least 3 0% for th e engine coolant.

If it is necessary to perf orm the rust-prevention operation while the machine is indoors, open the doors and windows t o improve ventilation and prevent gas poisoning. During storage, op erate and move the machine for a short distanc e once a month so that a new film of oil will coat moving parts. At t he same time, also charge the battery. draulic piston rod. Before operating t he work equipment, wipe the grease off the hy If the machine is e quipped with an air conditioner, operate the air conditioner for 3 to 5 minute s once a month to lubricateall parts o check the refrigera f the air conditionercompressor. Always run th e engine at low idle when doin g this.

In addition, nt level twice a year. NOTICE If the machine has bee n stored without carrying out the monthly rust-prev ention operation, consult your Komatsu d istributor before using it. When using the mac hine after long-term storage, do as follows bef ore using it. Wipe off the greas e from the hydraulic cylinder rods. at all lubrication points. Add oil and grease When the machine is stored for a long period, moisture in the air w ill mix with the oil. Check the o il before and after starting the engine . If there is water in the oil, change all the oil.