Komatsu — HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC

. MAINTENANCE OUTLINE OF SERVICE 4 - 6 FUEL To prevent the moisture in the air from cond ensing and forming water inside the fuel tank, always fill the fuel tank after completing the day's work. d if fuel containing water or dirt is used, it cannot work properly. t in when storing or adding fuel. rature in the Operation and Maintenance Manual. The fuel pump is a precision instrument, an d if fuel containing water or dirt is used, it cannot work properly. Be extremely careful not to let impurities ge Always use the fuel specified for the tempe If the fuel is used at temperatures lower t °C (5°F), the fuel will solidify.

If the fuel is used at temperatures higher result in problems such as a drop in outp han the specified temperature (particularly at temperatures below -15 than the specified temperature, the viscosity will drop, and this may ut. Before starting the engine, or when 10 minu tes have passed after adding fuel, drain the sediment and water f rom the fuel tank. If the engine runs out of fuel, or if the filters have been replaced, it is necessary to bleed the air from the circuit. If there is any foreign material in the fuel ta nk, wash the tank and fuel system. NOTICE Always use diesel oil for the fuel.

To ensure good fuel consumption characteristics an d exhaust gas characteristics, the engine mounted on this machine use s an electronically controlled high-pressure fuel injectio n device. This device requires high precision parts and lubrication, so i f low viscosity fuel with low lubricating ability is used, th e durability may drop markedly. COOLANT AND WATER FOR DILUTION reventing corrosion as well as preventing freezing. ssue, the use of antifreeze coolant is essential.

The coolant has the important function of p Even in the areas where freezing is not an i Komatsu machines are supplied with Koma excellent anticorrosion, antifreeze and cooli As a basic rule, we do not recommend t (AF-NAC). If you use another coolant, it ma of the cooling system that use light metals tsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has ng propertiesand can be used continuously for 2 years or 4000 hours. he use of any coolant other than Komatsu genuine supercoolant y cause serious problems such as corrosion of the engine and p arts such as aluminum. AC), there is no need to use a corrosion resistor. For details, see PAGE 4-21)".

stilled water or tap water (soft water). ll water (hard water), contains large amounts of minerals (calcium, When using Komatsu Supercoolant (AF-N "CLEAN INSIDE OF COOLING SYSTEM ( When diluting the antifreeze coolant, use di Natural water, such as a river water or we magnesium, etc.), and this makes it easier f inside the engine or radiator, it is extreme exchange, so when you dilute the coolant, than 100 PPM. or scale to form inside the engine or radiator. Once scale is deposited ly difficult to remove. It also causes overheating due to poor heat we recommend that you use water with an overall hardness of less precautions given in the Operation and Maintenance Manual.

to keep it away from flame. er differs according to the ambient temperature. LEAN INSIDE OF COOLING SYSTEM (PAGE 4-21)". When using antifreeze, always observe the Antifreeze coolant is flammable, so be sure The ratio of Supercoolant (AF-NAC) to wat For details of the ratio when mixing, see "C Even in areas where it is not necessary to least 30% to prevent corrosion of the coolin Supercoolant (AF-NAC) may be supplied in prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at g system. premix. In this case, never add diluting water. to cool before adding coolant.

If the engine overheats, wait for the engine If the coolant level is low, it will cause overhe ating, and will also cause problems with corrosion due to air entering the coolant.