Komatsu — HANDLING HYDRAULIC SYSTEM

. MAINTENANCE OUTLINE OF SERVICE HANDLING HYDRAULIC SYSTEM 4 - 9 During oper ations and af ter completion of o perations, t he hydraulic equipme nt is at a high te mperature.

During operations, i t is also unde r high pressure, so when carrying ou t inspection an d maintenance o f hydraulic related equipment, be careful of the following point Stop the machine on flat ground, lower quipm operation so that ther e is no pressure on the cylinde r circui Always s top the engin Immediat ely after sto pressure, so wait for t he oil temperature to go down before starting maint Even aft er the tempe rature has gone down, some parts may still be loosening plugs, bolts , or hose connecti release th e internal pr essure before rem When car rying out ins pection and mainte nance of th e hydraulic circuit, al ways release the air in the h ydraulic tank to re move the int ernal pressure.

Inspection a nd maintena an d replacement of hydr If h igh-press urehoses ha ve been removed, check that th ere is no damage to t he O-rings. If an y damage i s found, replace the O-ring. It is necessa ry to bleed th e air from the circu its when th e hydraulic filter elem ent or strainer h ave been r eplaced or washed, o r when hydr aulic equipment ha s been repaired o r replaced, or when the hydraul ic piping h as been removed. Th handled incorrectly. For details of the method of han dling, see "C HECKING CHARGE PRESSURE OF NITROGE N GAS IN ACCUMULATOR (FO R CONTROL CIR CUIT) (PAG E 4-70