. MAINTENANCE SERVICE PROCEDURE CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT WARNING NOTICE INSPECTION FOR MACHINES EQUIPPED WITH AIR CLEANER CLOGGING MONITOR (1) of the monitor panel flashes, NOTICE 4 - 25 Always wea r protective glas ses, dust mask , or other prot ective equipment. When remo ving the air clean er element fro m the air clean er body, i t is dangerous to pull it out by for When worki ng at high places or where the f oothold is poo r, be careful not to fall because of the reacti on when pulling out the outer eleme CHECKING When the yel low piston insid e red zone (A ) of the dust indicator (1) overlaps the red zone, cl ean the air cleaner element. After tton.
fter cleaning, pre ss the reset bu Always wait fo r the yellow piston in the dust indicator to overlap the red zone on the ou tside before clea ning the eleme nt. e yellow piston in the dust If t he element is cleaned frequ ently before th ust indicator over laps the red zon e on the outs ide, the air cl eaner will be unable to dis play its normal performance and the cleaning effect will will become poor. In addition, th e frequency of d ust stuck to th e element falli ng inside the inner element during the cleani ng operation w ill increase.
(If equipped) If air cleaner clean the air cleaner elemen Do not clean t he air cleaner ele ment until the a ir cleaner clo gging monitor on the monito r panel flashes. If the element i s cleaned freq uently before the clogging m onitor flashes, th e air cleaner w ill not be able to displa y its performance f ully, and the clea ning efficiency will also go d In addition, du ring the cleaning operation, mo re dirt stuck t o the element wil l fall inside the inner element